Mining is the classic slurry pump duty. From mill discharge to shaft dewatering, the slurry carries coarse, angular solids at high concentration, and the wetted parts sit in a constant erosion stream. What decides downtime is not the pump price but the material of the impeller and liners, and the clearance between them.
Duty characteristics, wear patterns, selection notes and common questions for this industry, with the matching series and wear parts.

Common combinations; the final choice follows a duty calculation.
| Duty condition | Selection and material |
|---|---|
| Coarse, highly abrasive | High-chrome alloy wetted parts (A05 / Cr26 type); rubber would be cut by sharp particles |
| Fine with corrosion | Rubber or polyurethane wetted parts: wear plus corrosion resistance at lower cost |
| High concentration, long distance | Lower speed with a larger impeller; balance efficiency against wear rate |
| Frequent starts, entrained air | Check NPSH margin; consider a sump pump or a larger suction line |
Model pages list construction, code explanation and chart extracts; part pages list basic number and material.

Mainly high-chrome wear alloy (A05 / Cr26 / Cr27); rubber or p…

High-chrome wear alloy, wear-resistant rubber or polyurethane:…

High-chrome wear alloy or rubber; metal parts are preferred fo…

High-chrome wear alloy, rubber lining or wear/corrosion-resist…
Coarse angular solids plus high velocity. The impeller outlet and vane backs are the fastest points in the pump. If the alloy is too soft, or the pump runs far from its best efficiency point, wear accelerates quickly.
Only for fine, rounded particles. Rubber is cut and torn by sharp coarse solids, so mining duties normally stay with high-chrome alloy.
There is no fixed interval. Measure impeller OD and liner thickness, and set a replacement limit by remaining wall thickness or head loss rather than by months.
Medium, concentration, particle size, flow and head are enough to propose a pump, a material and a spare-parts list. For a replacement, a nameplate photo confirms the part numbers.
We reply within one business day. You can also call +86 188 0321 2220.
Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.