Shijiazhuang Zhongqian Pump Industry Co., Ltd. · Slurry pumps / Spare parts / Technical support
ZQZhongqian PumpZHONGQIAN PUMP
Home/Applications/Mining
APPLICATIONS · MINING

Slurry pumps for MiningCoarse solids, high concentration and continuous duty: wear resistance decides uptime.

Mining is the classic slurry pump duty. From mill discharge to shaft dewatering, the slurry carries coarse, angular solids at high concentration, and the wetted parts sit in a constant erosion stream. What decides downtime is not the pump price but the material of the impeller and liners, and the clearance between them.

Duty characteristics, wear patterns, selection notes and common questions for this industry, with the matching series and wear parts.

AH series slurry pump in mining duty
Mining
DUTY

Duty characteristics

SELECTION

Pump and material by duty

Common combinations; the final choice follows a duty calculation.

Duty conditionSelection and material
Coarse, highly abrasiveHigh-chrome alloy wetted parts (A05 / Cr26 type); rubber would be cut by sharp particles
Fine with corrosionRubber or polyurethane wetted parts: wear plus corrosion resistance at lower cost
High concentration, long distanceLower speed with a larger impeller; balance efficiency against wear rate
Frequent starts, entrained airCheck NPSH margin; consider a sump pump or a larger suction line
MATCHING RANGE

Recommended series and wear parts

Model pages list construction, code explanation and chart extracts; part pages list basic number and material.

FAQ

Mining slurry pump questions

Why do impellers wear so fast in mining?

Coarse angular solids plus high velocity. The impeller outlet and vane backs are the fastest points in the pump. If the alloy is too soft, or the pump runs far from its best efficiency point, wear accelerates quickly.

Can a rubber impeller replace a metal one?

Only for fine, rounded particles. Rubber is cut and torn by sharp coarse solids, so mining duties normally stay with high-chrome alloy.

How often should wear parts be replaced?

There is no fixed interval. Measure impeller OD and liner thickness, and set a replacement limit by remaining wall thickness or head loss rather than by months.

Next step

Send the mining duty parameters

Medium, concentration, particle size, flow and head are enough to propose a pump, a material and a spare-parts list. For a replacement, a nameplate photo confirms the part numbers.

Selection support for Mining

We reply within one business day. You can also call +86 188 0321 2220.

Your details are used for this inquiry only.

Model and spare part identification

Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.

Click outside or press Esc to close
☎Call✉Email⇄Inquiry