Most failed replacements are not assembly failures. The part fits, then fails soon after, because preparation, clearance or commissioning was skipped.
1. Before dismantling
- Isolate and lock off Switch off, lock out and wait until the impeller has stopped.
- Drain and flush Empty the chamber and pipeline and flush with clean water.
- Record the baseline Clearance, bolt positions, gasket thickness and seal condition.
- Prepare tools Release ring, puller, torque wrench and lifting gear; avoid hammering.
2. What to check on strip-down
| Item | What to check |
|---|---|
| Impeller and liner clearance | Out of limit, and whether wear is one-sided (points to misalignment) |
| Liner sealing faces | Ring grooves, rubber blisters, debonding |
| Shaft sleeve | Groove depth, breakthrough to the shaft journal |
| Shaft | Straightness, journal size, thread and keyway |
| Bearing assembly | Clearance, heat marks, emulsified oil |
| Casing joint face | Flatness, erosion pits from particles |
3. Three controls during assembly
Clearance: set to the manual value using gaskets and machined faces, never by over-tightening bolts. Cleanliness: no particles on joint faces or in bolt holes. Preload: tighten diagonally in stages to the specified torque.
4. Commissioning checklist
- Rotation Bump the motor and confirm direction; reverse rotation damages impeller and seal.
- Vibration and noise Record at no load and on load; investigate abnormal vibration.
- Bearing temperature Compare with the manual limit and watch the trend.
- Leakage Slight packing drip is normal; a mechanical seal should not leak visibly.
- Flow and current Compare with pre-overhaul values; a clear drop points to clearance or a blockage.
Treat a part replacement as a small overhaul: record before, control clearance during, confirm at commissioning.