Shijiazhuang Zhongqian Pump Industry Co., Ltd. · Slurry pumps / Spare parts / Technical support
ZQZhongqian PumpZHONGQIAN PUMP
Home/News & blog/Slurry Pump Parts Replacement Checklist
NEWS & BLOG · SERVICE

Slurry Pump Parts Replacement ChecklistFrom isolation to commissioning

Wear parts failing soon after replacement usually reflect preparation, clearance or commissioning: isolation and flushing, strip-down inspection, assembly controls and commissioning checks.

Most failed replacements are not assembly failures. The part fits, then fails soon after, because preparation, clearance or commissioning was skipped.

1. Before dismantling

  • Isolate and lock off Switch off, lock out and wait until the impeller has stopped.
  • Drain and flush Empty the chamber and pipeline and flush with clean water.
  • Record the baseline Clearance, bolt positions, gasket thickness and seal condition.
  • Prepare tools Release ring, puller, torque wrench and lifting gear; avoid hammering.

2. What to check on strip-down

ItemWhat to check
Impeller and liner clearanceOut of limit, and whether wear is one-sided (points to misalignment)
Liner sealing facesRing grooves, rubber blisters, debonding
Shaft sleeveGroove depth, breakthrough to the shaft journal
ShaftStraightness, journal size, thread and keyway
Bearing assemblyClearance, heat marks, emulsified oil
Casing joint faceFlatness, erosion pits from particles

3. Three controls during assembly

Clearance: set to the manual value using gaskets and machined faces, never by over-tightening bolts. Cleanliness: no particles on joint faces or in bolt holes. Preload: tighten diagonally in stages to the specified torque.

4. Commissioning checklist

  • Rotation Bump the motor and confirm direction; reverse rotation damages impeller and seal.
  • Vibration and noise Record at no load and on load; investigate abnormal vibration.
  • Bearing temperature Compare with the manual limit and watch the trend.
  • Leakage Slight packing drip is normal; a mechanical seal should not leak visibly.
  • Flow and current Compare with pre-overhaul values; a clear drop points to clearance or a blockage.

Treat a part replacement as a small overhaul: record before, control clearance during, confirm at commissioning.

FAQ

Questions about this topic

Must gaskets be replaced every time?

Yes, recommended. A compressed old gasket makes clearance and sealing unpredictable.

Flow is low after assembly. What first?

Check rotation, clearance, pipeline blockage, valve position and actual speed.

How much packing drip is normal?

A slight continuous drip for lubrication and cooling; no drip at all means the gland is too tight.

Inquiry

Send the model and the duty

The methods described here only become useful when they are applied to a specific pump. Send a nameplate photo, a worn-part photo or the duty data and we will confirm part numbers and material.

Technical inquiry

We reply within one business day. You can also call +86 188 0321 2220.

Your details are used for this inquiry only.

Model and spare part identification

Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.

Click outside or press Esc to close
☎Call✉Email⇄Inquiry