"Rubber is not wear resistant" is one of the most common misconceptions in slurry pumping. In the right duty rubber can outlast metal several times over; in the wrong duty it can be cut through in days.
1. Two different wear mechanisms
Metal resists wear through hardness: particles cut and fatigue the surface microscopically. Rubber absorbs impact through elastic deformation, so fine particles bounce off. That makes rubber very effective against fine continuous erosion.
Rubber, however, cannot resist cutting. Sharp coarse particles slice the lining, and the split then propagates. This is exactly why rubber performs well in fine grinding circuits and poorly in coarse mine discharge.
2. Four tests
| Test | Favours rubber | Favours metal |
|---|---|---|
| Particle size | Fine, about 10 mm and below | Coarse, gravel |
| Particle shape | Rounded, milled | Sharp, angular, flaky |
| pH | Neutral to mildly acid or alkaline | Strong acid or alkali |
| Temperature | Within the compound limit | Above the compound limit |
3. Mixed builds are normal
A pump does not have to be all metal or all rubber. A common combination is a metal impeller with rubber liners: the impeller takes the strongest impact and needs structural strength, while the liners mainly see erosion, where rubber is lighter and cheaper.
4. Compare cost per hour, not unit price
Rubber parts are usually cheaper and lighter, and faster to fit. The real comparison has three parts: price divided by service life, downtime and labour for replacement, and the effect on power consumption. Only the sum of the three is the true cost of a part.
5. Points to watch with rubber
- Core and bonding Most rubber part failures start at the bond; core preparation and vulcanising decide life.
- Lining thickness Too thin wears through, too thick disturbs the passage.
- Fitting Never force a lined part; tighten bolts evenly to avoid deforming sealing faces.
- Storage Keep away from light and heat, store flat and unloaded, and check for ageing before use.
Rubber and metal are not substitutes; they are different tools. Use particle size, shape, pH and temperature to choose, then discuss price.