Shijiazhuang Zhongqian Pump Industry Co., Ltd. · Slurry pumps / Spare parts / Technical support
ZQZhongqian PumpZHONGQIAN PUMP
Home/Slurry Pump Liner Supplier
SLURRY PUMP LINER SUPPLIER

Slurry Pump Liner SupplierFront liners, frame plate liners and volute liners by basic part number

Slurry pump liners: front liner (throatbush), frame plate liner and volute liner, supplied by basic part number (041, 083, 110) in high-chrome alloy or rubber.

Liner price differences come mostly from material and wall thickness; performance differences after replacement come mostly from clearance setting. Both have to be right before a liner change is worth doing.

Slurry pump volute liner
Slurry Pump Liner Supplier
LINER SET

What a liner set includes

Front liner, frame plate liner and volute liner form the pump chamber.

PartPosition and functionWear symptom
Front linerBetween cover plate and impeller eye; forms the inlet sealing faceRing grooves in the bore, falling flow and NPSH
Frame plate linerBehind the impeller on the drive side; forms the sealing chamberInternal recirculation, falling efficiency
Volute linerLines the casing to form the volute passageCutwater and discharge grooving, falling head, vibration
Cover plate linerCompletes the chamber and matches the volute linerJoint leakage and local erosion
CLEARANCE

Clearance, not wall thickness, decides performance

The narrow gap between impeller and liners limits internal recirculation. As it opens, part of the slurry circulates inside the pump instead of leaving through the discharge: flow and head fall, power consumption rises, and the pump still sounds normal.

Replacing liners therefore means measuring and setting the clearance to the manual value, confirming gasket thickness, cleaning the joint faces and re-checking after the first run.

MATERIAL

Metal or rubber

MaterialUseAvoid
High-chrome alloyCoarse, abrasive, higher temperatureStrong corrosion without a corrosion-resistant grade
Rubber liningFine particles, mild acid or alkali, low noiseSharp coarse solids, high temperature
PolyurethaneFine particles needing wear plus elasticityHot or swelling media
Wear-resistant alloyWear and corrosion togetherCost must be justified by life
FAQ

Slurry Pump Liner Supplier — frequently asked questions

Can only the front liner be replaced?

Yes, but check the other liners at the same time. If they are grooved, recirculation stays high and performance recovery is limited.

Does a worn-through liner damage the casing?

Yes. Once the liner is through, slurry erodes the casing bore and can require a casing replacement, so liners should be changed on thickness readings.

How do I decide when a liner is worn out?

Three checks: grooving on the sealing face, wall thickness against the wear limit, and measurable loss of flow or head. Time in service alone is unreliable.

Is rubber suitable for liner sets?

For fine particles, mild chemicals and moderate temperature. Sharp coarse solids cut the rubber and higher temperature ages it.

Next step

Send the duty or the part number

For a pump, send medium, flow, head, concentration and site conditions. For parts, send the pump model, frame code and basic part number, or a photo of the worn part. We normally confirm the item and price within one business day.

Send an inquiry

We reply within one business day. You can also call +86 188 0321 2220.

Your details are used for this inquiry only.

Model and spare part identification

Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.

Click outside or press Esc to close
☎Call✉Email⇄Inquiry