The G is a single-casing, wide-passage pump built for gravel, sand slurry and large solids, with a discharge that rotates to any position for boat and mobile installations. Models run from 6/4D-G to 14/12G-G; GH is the high-head variant.
Construction, model range, wetted materials and duty limits for this series. Figures come from the charts and manuals on file; values not published are marked "per supplied documents".

Horizontal, single-casing, large-passage gravel / high-head gravel pump. G / GH gravel pumps use a single, unlined all-metal casing and a large-passage impeller for media carrying coarse gravel, pebbles or dredged sludge. GH is the high-head variant for solids too large for a conventional slurry pump.
Typical coverage: flow up to about 4320 m3/h, head up to about 80 m, with relatively large solids passage.
The industry pages behind these duties set out recommended series, wear parts and field checks.
Material follows the medium; sealing follows suction pressure and whether dilution is allowed.
Each part page lists the basic number, material options and applicable models. One basic number maps to different part numbers across frames, so check against the nameplate.

Mainly high-chrome wear alloy (A05 / Cr26 / Cr27); rubber or p…

Ductile iron, cast steel or wear-resistant alloy; in double-ca…

Ductile iron or cast steel, with the suction-side inner surfac…

Wear-resistant alloy, stainless or 3Cr13-type martensitic stee…

HT250 grey iron or QT500 ductile iron.
Excerpts that apply to this series; read the full text on the online reading page.
The G is single casing with a wide passage and an open or wide impeller for large solids; the AH is double casing with replaceable liners for dense, fine, highly abrasive slurry. They are not interchangeable.
GH is the high-head variant of the G series, similar in construction with impeller and casing designed for more head. See the model pages for data.
Yes, with material chosen for chloride and sand content. Standard high-chrome iron has limited corrosion resistance in seawater, so evaluate corrosion-resistant alloy or rubber-lined options for continuous duty.
Send the medium, particle size and solids content, flow, head, pH and temperature, plus installation conditions (pit depth or line length). For parts, add the pump model or a photo of the worn part.
We reply within one business day. You can also call +86 188 0321 2220.
Please provide the pump model, nameplate data and duty parameters by phone or email. Performance charts and manuals can be read online.